by Tommy H. Thomason

Friday, March 16, 2018

Grumman F9F-2 Panther Length

2 April 2018: I've added some additional illustrations to explain the length change.

Well, there's your problem.
The F9F-2 Panther length is frequently (including on the National Naval Aviation Museum website) as 37' 6" (sometimes 37' 5 3/8"). That's almost certainly based on the original XF9F-2 SAC (Standard Aircraft Characteristics) chart as shown above.

However, the actual length was 37' 11 5/16" as shown, rounded down to 37' 11", on an F9F-2 SAC chart.
Note that this is exactly the same drawing. Only the overall length dimension with the nose cone closed has changed.

If it had been redrawn, the outline would have looked more like this Grumman dimensioned drawing.
The length change appears to have been limited to the vertical fin and extreme aft fuselage. I wouldn't spend too much time worrying about the slightly different wheel locations; in any event, I don't have enough data to establish which is correct. The original SAC drawing may be incorrect with respect to the location of aft end of the fuselage surrounding the tailpipe. It appears that on the XF9F-2 prototypes, it is farther aft, consistent with the production F9F-2's.
Close examination of XF9F-2s indicates that most if not all of the length change was the result of substituting a rudder of increased chord.
Note that the bottom of the production fin and rudder was different from BuNo 122477's , mainly by eliminating the narrow extension downward of the rudder and a triangular bit of the bottom of the fin immediately ahead of it.

Another view of the bottom of the production fin:

2 comments:

  1. Hi Tommy, Just to clarify- is this a definite change from prototype to production, or might it simply be a new drawing in which: A) the tail (or back end) is drawn differently, as well as wheel positions, and B) a length dimension is corrected?

    (Note: in line above second drawing, you put 37 inches instead of 37 feet. I know, people will figure it out...)

    ReplyDelete
    Replies
    1. Bob,

      This was a change made during the flight test of the F9F-2 prototype. I'll add a few illustrations to demonstrate that.

      Thanks for the dimension correction. I usually create these posts on my laptop and between the small screen and my deteriorating near vision, it's not easy for me to differentiate the foot and inch marks.

      Delete